High
Voltage Pulsed Galvanic Stimulation
Galvanic stimulation is most useful in acute injuries associated with major
tissue trauma with bleeding or swelling. In contrast to TENS and IFC units,
which apply alternating current, galvanic stimulators apply direct current.
The PGS-123 Galvanic Stimulator – is a single channel device with two active leads and one dispersive single lead output. It has a negative (heat) or positive (ice) polarity switch to improve circulation or reduce inflammation.
Direct current creates an electrical field over the treated area that, theoretically, changes blood flow. The positive pad behaves like ice, causing reduced circulation to the area under the pad and reduction in swelling. The negative pad behaves like heat, causing increased circulation, reportedly speeding healing. The Galvanic Stimulator (direct current) is the best modality for iontophoresis treatments.
High-voltage pulsed galvanic stimulation (HVPGS) is gaining widespread use for
wound healing, edema reduction and pain relief, Carpal Tunnel Syndrome and
Diabetic Foot are two major areas of use. Devices in this class are
characterized by a unique twin- peak monophasic
waveform with very short pulse duration (microseconds) and a therapeutic
voltage greater than 100 volts. The combination of very short pulse duration
and high peak current, yet low total current per second (Microcurrent)
allows relatively comfortable stimulation. Furthermore, this combination provides
an efficient means of exciting sensory, motor and pain-conducting nerve fibers.
Perceptual discrimination of those responses is relatively easy to achieve and
thus its clinical versatility. Back Ground Skin offers a great amount of
resistance to the flow of electrical current. When current is passed through a
circuit that contains resistors, voltage drop occurs and energy is lost. This
phenomenon occurs when traditional low voltage units are used in treatment A high voltage device produces a spontaneous breakdown in
skin resistance and HVPGS current passes through the skin with negligible
thermal and electrochemical effects. The first high voltage stimulator was
developed by Bell Telephone Laboratories in 1945. By decreasing the pulse
duration and increasing the voltage, the developers noted that deep tissues
could be stimulated without producing tissue damage. The first published report
(I 966) described its effectiveness in wound healing of animal limbs.
High-Voltage Pulsed Galvanic Stimulation
Comes with everything you need to get started:
1.
1 pair of
Lead Wires (these attach to the device on one end and the electrodes (or pads) on the other end
2. 12 FREE re-usable premium SoftBlue electrodes (Pads)
3. Instruction manual
4. Industrial strength heavy duty 9V battery.
5. Belt clip.
6.Carrying case.
7.Warranty.
TECHNICAL SPECS
- Channels: Single Channel.
-
Output: 0-240V Max. (Single Channel, Load 500 Ohm) 0-350V Max. (Open Circuit).
-
Wave Form: twin peak: Monophasic.
-
Amplitude: Output Voltage: 0 - 60mA (or 0 - 30V) (through 500 ohms).
-
Frequency: 2 to 100Hz.
-
Low battery: Lower Battery Indication.
-
Power Source: Yes with AC/DC wall adaptor rechargeable cell.
-
Size: 60.5x24.5x98.5.
-
Weight: 134 grams (including battery).
-
Stimulation Mode: Synchronous or Alternation.
Warranty Terms:
The warranty for this product covers the device itself and its power cord (where applicable). The warranty does not cover damages caused by normal wear and tear, misuse, or abuse of the device or any of its components. Please keep in mind that Lead Wires (the wires that connect the device to the electrodes) are not covered under the manufacturer’s warranty for this device. The periodic replacement of lead wires and disposable electrodes is part of the upkeep of any electrotherapy device.
|